E-TON Beamer Manuel de service télécharger pdf (Page 34)

Beamer Rev-2.0.2 Page 34 of 55 11/21/2005

7.9 DISASSEMBLY AND INSPECTION OF THE C.V.T. SYSTEM

Remove the engine clutch cover by unscrewing the

fixed bolts. Check the belt for wear. If necessary,

replace the belt. Disassemble the front drive pulley

and check the six rollers for wear. If necessary,

replace the rollers.

Remove the screws on the clutch cover at the left side

of the engine. Take off the clutch cover and gasket.

The belt, front pulley and rear pulley are now visible.

Unscrew the front pulley fixing nut. Remove the

front pulley carefully. Take out the six rollers from

the front pulley. Inspect the surface of the rollers. If

there is serious wear, replace with new rollers.

Inspect the belt. If it is broken or loose, replace with a

new one.

www.Get2itParts.com

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 64 65

Pas de commentaire

E-TON Beamer Manuel de service Page 34