E-TON Beamer Manuel de service Page 51

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 65
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 50
Beamer Rev-2.0.2 Page 51 of 55 11/21/2005
New battery preparation:
• The new battery is shipped dry with the electrolyte in a
separate container. Remove the battery cell caps and install the
electrolyte in the battery cells. CAUTION: Electrolyte contains
sulfuric acid that can cause severe burns if contact is made
with the skin or eyes. • Allow the battery to completely absorb
the electrolyte (approximately one (1) hour). The battery
should have a full charge. The battery is a gel acid battery and
will not show any liquid electrolyte when fully absorbed.
DO NOT place the new battery on a charger as this can
damage the cell plates and make the battery unusable.
Battery installation:
• Place the battery in the battery compartment.
• Clean the battery terminals and lead connectors of all dirt
and corrosion.
• Attach the positive (RED) lead to the [+] positive
terminal of the battery first.
• Attack the negative (BLACK) lead to the [-] negative
terminal of the battery next.
• Check the lead routing to ensure they are clear of
obstruction and do not fall between the battery and unit
body where they could be abraded or otherwise damaged.
• Attach the battery retainer strap to secure the battery in
place.
Battery charging:
• If the battery become discharged or shows low
voltage you can recharge the battery using a 12 volt
battery trickle charger.
• Connect the positive lead of the charger to the
positive terminal of the battery.
• Connect the negative lead of the charger to the
negative terminal of the battery.
• Turn on the charger and allow the battery to charge
from 4 to 6 hours.
• Test the battery voltage after charging it should give
a reading of between 12-and 13 volts.
• If after charging the battery is still indication a low
voltage or the battery will not hold the charge for
more than a day or two the battery should be
replaced.
ETON recommends replacing the battery every two years for optimal performance.
www.Get2itParts.com
www.Get2itParts.com
www.Get2itParts.com
Vue de la page 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 64 65

Commentaires sur ces manuels

Pas de commentaire