E-TON Beamer Manuel de service télécharger pdf (Page 27)

Beamer Rev-2.0.2 Page 27 of 55 11/21/2005

Measure the piston pin bore, and the piston pin

outer diameter.

Pin outer diameter Service limit: 10.04 mm

Pin bore Service limit: 9.96 mm

Measure the connecting rod small end inner

diameter with a small hole-gauge.

Service limit: 14.06 mm

6.4 INSTALLATION

Install the piston rings with the marks facing up.

Do not damage the piston rings by spreading the

ends too far.

Note: The piston ring gap must align with the ring

pin in the ring groove of piston.

Clean the cylinder gasket surface, being careful

not to drop any gasket material into the crankcase.

Apply some oil to the inside of the connecting rod

small end.

Install the piston, piston pin, and clip.

Install the piston with the arrow mark facing the

exhaust pipe.

www.Get2itParts.com

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 64 65

Pas de commentaire

E-TON Beamer Manuel de service Page 27